Home
JAQForum Ver 24.01
Log In or Join  
Active Topics
Local Time 23:26 24 Nov 2024 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Microcontroller and PC projects : LOAD command question

     Page 2 of 2    
Author Message
phil99

Guru

Joined: 11/02/2018
Location: Australia
Posts: 2135
Posted: 11:48am 23 Aug 2024
Copy link to clipboard 
Print this post

  electricat said  And sometimes jumping through multiple files it starts to be bored many times type in LOAD " {and some long name}

As a slow, error prone hunt-and-peck typist my solution, when using TeraTerm is to type 'Files' then 'edit " ' or 'run " ' etc then use the mouse to highlight the required file name then press Alt-V to paste it to the command line after edit " then follow with the final ".

So I end up with:-

edit "Long_file_name.bas"

with a little less typing an no errors in the name.
 
electricat

Senior Member

Joined: 30/11/2020
Location: Lithuania
Posts: 161
Posted: 04:30pm 23 Aug 2024
Copy link to clipboard 
Print this post

@phil99

Good tip. Saves time.  
 
     Page 2 of 2    
Print this page


To reply to this topic, you need to log in.

© JAQ Software 2024