Home
JAQForum Ver 24.01
Log In or Join  
Active Topics
Local Time 00:02 12 Nov 2026 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Microcontroller and PC projects : Pico Computer 3 - One board to rule them all

     Page 11 of 11    
Author Message
cdeagle
Senior Member

Joined: 22/06/2014
Location: United States
Posts: 273
Posted: 09:14pm 10 Nov 2026
Copy link to clipboard 
Print this post

Is it possible to plug the PicoMite 3 into a PC and use TeraTerm and MM Edit 5?
 
phil99

Guru

Joined: 11/02/2018
Location: Australia
Posts: 3429
Posted: 09:32pm 10 Nov 2026
Copy link to clipboard 
Print this post

It has a built-in serial to USB adapter (U7 - CH340) for the serial console, connected to COM2 on GP8 & 9.
The console USB-C socket (USB2) is near the HDMI socket.
.
Edited 2026-11-11 07:49 by phil99
 
TassyJim

Guru

Joined: 07/08/2011
Location: Australia
Posts: 6638
Posted: 09:51pm 10 Nov 2026
Copy link to clipboard 
Print this post

  cdeagle said  Is it possible to plug the PicoMite 3 into a PC and use TeraTerm and MM Edit 5?


Depending on which firmware you have loaded, MMEdit will connect to the USB "firmware update" port just like a "normal" picomite.
If you load one of the standalone firmwares, you use the serial-USB adapter which is part of the PC3. In this case you have to be sure to use the correct baud rate. Usually 115200

Jim
VK7JH
MMedit
 
cdeagle
Senior Member

Joined: 22/06/2014
Location: United States
Posts: 273
Posted: 10:08pm 10 Nov 2026
Copy link to clipboard 
Print this post

Thanks guys. That worked especially when I turned on the power switch.

Call me old fashioned.
 
     Page 11 of 11    
Print this page


To reply to this topic, you need to log in.

The Back Shed's forum code is written, and hosted, in Australia.
© JAQ Software 2026