Home
JAQForum Ver 24.01
Log In or Join  
Active Topics
Local Time 03:27 22 Nov 2024 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : For Sale : Windmill nearly complete bar painting!

Author Message
domwild
Guru

Joined: 16/12/2005
Location: Australia
Posts: 873
Posted: 09:16am 24 Apr 2019
Copy link to clipboard 
Print this post

Hi,

Am clearing out the garage and must sell my beloved Littleford-style mill due to the management wishing to leave our five-acre rural lot with lots of summer easterlies.

Three PVC props, 1300 long, 1470 from tip to shaft. Shaft is a mix of light SS pipe and gal pipe, not a full-round build.

50mm mast ready and 60mm long pipe for further mast. Rudder is ready.

Wire, tensioners and shackles are available, as is extra SS pipe.

Stator is wound for 36V due to a present of a 36V UPS and has not been de-cogged.

Perth pick up only. Make a reasonable offer and the whole box and dice is yours!

Photos will be on Gumtree.
Edited 2020-07-15 18:08 by domwild
Taxation as a means of achieving prosperity is like a man standing inside a bucket trying to lift himself up.

Winston Churchill
 
Print this page


To reply to this topic, you need to log in.

© JAQ Software 2024