Home
JAQForum Ver 24.01
Log In or Join  
Active Topics
Local Time 05:34 24 Nov 2024 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Electronics : New DC plug standard announced!

Author Message
South Easter

Newbie

Joined: 18/06/2007
Location:
Posts: 36
Posted: 02:32pm 16 Sep 2007
Copy link to clipboard 
Print this post

Ladies and gents.... I give you the Gill-SouthEaster Standard for DC plugs (GSSD#000)!

After extensive research involving several minutes on Google and this forum, the following is found to be an appropriate standard for plug sockets for DC systems:

Two flat pins one above the other, and at ninety degrees to each other. The horizontal pin shall be negative, and the vertical positive. Example is Clipsal part# 492/32

Now we all we need to do is work out something for 12V/24V and maybe 36V...sigh.
South Easter
http://windpower.org.za
 
Print this page


To reply to this topic, you need to log in.

© JAQ Software 2024