Home
JAQForum Ver 24.01
Log In or Join  
Active Topics
Local Time 03:53 26 Nov 2024 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Electronics : making pcb’s with clove oil

Author Message
isochronic
Guru

Joined: 21/01/2012
Location: Australia
Posts: 689
Posted: 10:48pm 26 May 2012
Copy link to clipboard 
Print this post

I have found a very easy way to "toner-transfer" for protoypes...
after cleaning the copper, spread a very small amount of
clove oil on it, and then press the laserprint onto the
pcb. Use heavy pressure (stand on it).
Carefully (gradually) moisten the paper until it is wet through.
Peeling the paper off leaves the toner stuck fast, quite
resistant to removal.

I guess the clove oil has eugenol which binds to metals,
or maybe it's just gummy You have to scrub the
copper with the oil a bit for the best results. Using too
much oil in the final step gives fuzziness and less adhesion.

How renewable is that !!! I wouldn't use it for large pcbs
though, the paper expands etc.
 
JakeStew
Newbie

Joined: 02/12/2012
Location: United States
Posts: 11
Posted: 01:08am 02 Dec 2012
Copy link to clipboard 
Print this post

That sounds really cool! Thanks for the tip.

Have you tried this with press-n-peel blue or dissolvo type paper?

Or is this just for direct toner transfer with regular paper?


-Jake
 
isochronic
Guru

Joined: 21/01/2012
Location: Australia
Posts: 689
Posted: 09:47pm 03 Dec 2012
Copy link to clipboard 
Print this post

I've only used regular paper and HP toner so far,
it works ok (usually). Use the darkest print
settings though.
 
Print this page


To reply to this topic, you need to log in.

© JAQ Software 2024