Home
JAQForum Ver 24.01
Log In or Join  
Active Topics
Local Time 11:18 24 Nov 2024 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Electronics : Opening a MOSFET with a MOSTFET - how?

Author Message
macm
Newbie

Joined: 26/03/2008
Location: Sweden
Posts: 4
Posted: 11:31pm 13 Apr 2008
Copy link to clipboard 
Print this post

Hi all.
Thanks for the help on the current-sensing for the piclog. I ordered a current sensor sample from Allegro and that works perfect.
Now my problem is that I want the Piclog to open a paralel series of MOSFETS. The problem seems to be that the MOSET on the Piclog-board opens the negative and that it takes a positive to open the the paralel series of stronger MOSFETS.
How do I use the negative(-) to create a posetive (+)??

(I have 12 MOSFETs in paralel that is to open 800w/13v to a dumpload)

Regard from Gotland - sweden
Mikkel
 
Robb
Senior Member

Joined: 01/08/2007
Location: Australia
Posts: 221
Posted: 04:33am 17 Apr 2008
Copy link to clipboard 
Print this post

A simple in inverter (inverter as in logic state inverter not power inverter). Something like...

A rather basic drawing but ....
 
macm
Newbie

Joined: 26/03/2008
Location: Sweden
Posts: 4
Posted: 08:26am 17 Apr 2008
Copy link to clipboard 
Print this post

Okey - logic state inverter. I tried the wiki and came up with: Inverter (logic gate)
(Im so in over my head :-)
http://en.wikipedia.org/wiki/Inverter_(logic_gate)
Is this the thing?

Regards MikkelEdited by macm 2008-04-19
 
Robb
Senior Member

Joined: 01/08/2007
Location: Australia
Posts: 221
Posted: 06:09am 22 Apr 2008
Copy link to clipboard 
Print this post

Thats the general idea you want as far as I can tell from your first post.

Basicly:
logic high in ---> logic low out.
Logic low in ----> logic high out.

The above circuit does that.
Do you understand transistor basics? If not that would be a good place to start.

You could use an actual off the shelf logic gate chip but thats probably over kill for what you want.
 
GWatPE

Senior Member

Joined: 01/09/2006
Location: Australia
Posts: 2127
Posted: 07:00am 22 Apr 2008
Copy link to clipboard 
Print this post

Hi Mikkel,

You have a piclog cct and you presumably have downloaded the code to the picaxe. You would have to modify the code to use a hall effect current sensor.

All you probably need to do is mod the code. I think it is output 2 that is used. Substitute a low for a high and vice versa in the code. Check that it is output 2.

No soldering or understanding transistors may be needed. .. Gordon.
become more energy aware
 
Print this page


To reply to this topic, you need to log in.

© JAQ Software 2024