Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.
|
Forum Index : Windmills : delta wiring on F & P
Author | Message | ||||
F&P murray Newbie Joined: 25/10/2005 Location: AustriaPosts: 22 |
Glenn has avery good rewiring schematic on rewiring an F & P into 7 two pole star and then star/delta, is there a a diagram similar that shows delta wiring only, has any one got one.
Bob from Murray Bridge, SA |
||||
ozetrade Regular Member Joined: 15/10/2005 Location: AustraliaPosts: 59 |
Hi Bob, I haven't seen any diagrams other than what's in the Eco Innovation manual. It's a fairly straight forward process though. Start anywhere. In a clockwise direction, put the numbers 2-1 on the first post, 4-3 on the second post, 6-5 on the third post. Repeat this all the way around the stator. Cut all the wires. Join all the wires numbered 1 and number the end wire No.1 when done. Join all the wires numbered 2 and number the end wire No.2 when done. etc. When finished you should have 6 wires numberd 1-6. Join 1 & 5 - join 2 & 6 - Join 3 & 4. DONE
Greg Just North of Brisbane in Redcliffe OZeTrade.net |
||||
F&P murray Newbie Joined: 25/10/2005 Location: AustriaPosts: 22 |
Thanks ozetrade, i will rewire a unit this weekend and see what i can get, im lucky i have a sh*t load of wind here having destroyed unit 1 already pictures to come on monday.
theres cheap power in gas but you have to sit on a vessel to collect it.
Bob Bob from Murray Bridge, SA |
||||
Print this page |