Home
JAQForum Ver 24.01
Log In or Join  
Active Topics
Local Time 08:24 23 Nov 2024 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Windmills : F & P 48volts

Author Message
nzseagull

Newbie

Joined: 07/06/2006
Location: New Zealand
Posts: 17
Posted: 06:49am 15 Jun 2006
Copy link to clipboard 
Print this post

Hi
I have just build a very handy F & P test bed with a 2 hp AC motor save time and easer that playing up the pole ;-)
I have used the Star/ delta system bit more work but worth the extra
Now can any one tell me how to re config/wire an F&P to up the output voltage to around 48 volts

Thanks Bevin
 
makourain

Senior Member

Joined: 19/04/2006
Location:
Posts: 111
Posted: 11:58am 15 Jun 2006
Copy link to clipboard 
Print this post

dont quote me on this but i think this is how u change the output of the smart drive.

as it stands u get 14 groups of 3 which produces high volts and low current.
we rewire it to be 6 groups of 7 which produces low voltage and high current.

playing around with those groups is what u gotta do.
 
brucedownunder2
Guru

Joined: 14/09/2005
Location: Australia
Posts: 1548
Posted: 05:27pm 17 Jun 2006
Copy link to clipboard 
Print this post

whatu gotta do is read up the diary's and glenns site-lots of reading ,nobody is gunna build it for u .
Remember ,it's all there ,just do the reading,we all had to do that.
Grumpy old man,Bruce
Bushboy
 
dwyer
Guru

Joined: 19/09/2005
Location: Australia
Posts: 574
Posted: 04:21am 18 Jun 2006
Copy link to clipboard 
Print this post

Yes yes I do agree with Brucedowerunder2 and it's all there and just do the reading and there are heap and heap of information on the webs site if you dont know what or how is work or use you own skill and use it or what is it? and how things work?? Very simple look in webs site




Dwyer the Bushman
 
nzseagull

Newbie

Joined: 07/06/2006
Location: New Zealand
Posts: 17
Posted: 07:11am 18 Jun 2006
Copy link to clipboard 
Print this post

Thanks makourain
Yep thats was all I needed to know is all working now @ around 48 volts
Now Im working on Kevlar form core blades using a casting method to keep all the blades about same found a nice low cost way so see how it works out

Thanks    
 
Print this page


To reply to this topic, you need to log in.

© JAQ Software 2024