Home
JAQForum Ver 24.01
Log In or Join  
Active Topics
Local Time 01:28 22 Nov 2024 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Windmills : programming MX250

Author Message
palcal

Guru

Joined: 12/10/2011
Location: Australia
Posts: 1873
Posted: 09:47am 03 Oct 2024
Copy link to clipboard 
Print this post

I have a project that uses an MX250 and I need to load the hex file. I have a PicKit3 but always have trouble using it. I'm fairly sure this wont work but if I put the MX250 in a 170 backpack can I program it with the PicProg gui like I do with the 170 chip.
"It is better to be ignorant and ask a stupid question than to be plain Stupid and not ask at all"
 
phil99

Guru

Joined: 11/02/2018
Location: Australia
Posts: 2129
Posted: 12:05pm 03 Oct 2024
Copy link to clipboard 
Print this post

They are in the same family so it should work.

I have successfully programmed a couple of MX270 chips (one for Geoff's ASCII terminal and the other for the USB console version of MMBasic) using pic32prog.exe via an MM2 and TassyJim's MMflash windows front end.

It can also use an Arduino Nano. The MMflash.zip on his site has all the info.
 
Print this page


To reply to this topic, you need to log in.

© JAQ Software 2024