 Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me. |
Forum Index : PCB Manufacturing : Comms and Analog Sensor
| Author | Message | ||||
| carlm Newbie  Joined: 31/05/2018 Location: AustraliaPosts: 10 |
Hi, I have a project with a 44 pin Micromite Chip. I also have a level sensor that uses a comm port. I am after some code/guidance on how to proceed. The net result will be the level will sit in a variable. I assume that somehow I have to initially open the comm port and then assign a Pin to the variable. Thanks in advance |
||||
disco4now Guru  Joined: 18/12/2014 Location: AustraliaPosts: 896 |
Hi, Have a look at this thread. its about receiving data on a comm port and putting it into a variable. You will need to know what speed it comes in at or try different speeds if unknown and understand how the message is formatted. receiving from a comm port Gerry Latest F4 Latest H7 |
||||
 Print this page |
