 Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me. |
Forum Index : Microcontroller and PC projects : Old Pico W with new Image
| Author | Message | ||||
Dinosaur Guru  Joined: 12/08/2011 Location: AustraliaPosts: 321 |
Hi All I have not been following the extensive work carried out on the latest Pico Image as I usually only use the Zero W 2. However as a matter of interest I tried loading V6.00.01 into a two year old Pico and it failed. The Pico is marked as "Pico W 2022" and on the underside "IC:20953-PicoW" When I clear the flash and copy in an older Image "WebMiteV5.07.08RC17" it's all ok. When I load "WebmiteRP2040V6.00.01" it finished copying and then does not reboot. Resetting the power does not resolve it. Is there something obvious I am missing ? Regards Regards Hervey Bay Qld. |
||||
disco4now Guru Joined: 18/12/2014 Location: AustraliaPosts: 923 |
There was an issue with the download initially, just download again as its been refreshed. I have same board and now starts with the refreshed WebmiteRP2040V6.00.01 Latest F4 Latest H7 |
||||
| Dinosaur Guru Joined: 12/08/2011 Location: AustraliaPosts: 321 |
Hi All Thanks for that. I had done that before, but this time a phone call interrupted me and when I finished it was actually fired up. Perhaps it takes longer to boot than with previous images and I just got impatient. Regards Hervey Bay Qld. |
||||
 Print this page |
