Home
JAQForum Ver 24.01
Log In or Join  
Active Topics
Local Time 03:51 28 Nov 2024 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Microcontroller and PC projects : Rainy day project - hand held micromite

Author Message
gadgetjack
Senior Member

Joined: 15/07/2016
Location: United States
Posts: 146
Posted: 01:18am 09 Aug 2023
Copy link to clipboard 
Print this post


I bought one of these Smart-Response XE gadgets to play with from e-bay. I first tried the tiny basic on git-hub and found it less than impressive. So I thought why not try stuffing a micro-mite in the case and use the terminal software from get-hub as keyboard and display. Well it does work but not great. Had to slow down to 9600 baud. Now there is no way to exit the editor when you type in a program (no function keys) so back to a nice paper weight. But , I did make it sorta work so maybe I get a beer anyway. The rain stopped .....
 
Quazee137

Guru

Joined: 07/08/2016
Location: United States
Posts: 571
Posted: 03:23am 09 Aug 2023
Copy link to clipboard 
Print this post

See if you can change the sym to cntl then q w r t y  works same as the function
 keys or see what can be done with the gray keys.
 
 Quazee137
 
Frank N. Furter
Guru

Joined: 28/05/2012
Location: Germany
Posts: 831
Posted: 06:37am 09 Aug 2023
Copy link to clipboard 
Print this post

@gadgetjack:

Can you show me your schematic and your code? I have a SMART Response XE too.
Did you know that there is another interpreter?

https://www.instructables.com/SMART-Response-XE-With-New-Arduino-Basic-Port/

Frank
 
gadgetjack
Senior Member

Joined: 15/07/2016
Location: United States
Posts: 146
Posted: 09:30pm 09 Aug 2023
Copy link to clipboard 
Print this post

I am reworking the terminal code to make it more mmbasic friendly. All that I have so far can be found on github by searching for Smart Response XE. Get the terminal package. The schematic is on the site too. They are a bear to take apart , so I soldered the programming cable to the pads inside and fed it out the back. When its done I may remove it or keep it for more playing. A usbtinyisp programmer is needed. Cheap and everywhere.
I do not have the newest mmbasic loaded either as it was on another project from a while back. Its raining again today , so , back to work.
 
Print this page


To reply to this topic, you need to log in.

© JAQ Software 2024