 Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me. |
Forum Index : Microcontroller and PC projects : Question about OPTION KEYBOARD
| Author | Message | ||||
| Frank N. Furter Guru  Joined: 28/05/2012 Location: GermanyPosts: 828 |
I use a small USB keyboard where the keys share characters and numbers. NUMLOCK is active by default. If I understand the manual correctly, I should be able to change this permanently with "OPTION KEYBOARD GR,0,0". However, when I restart the computer, NUM is still active!?! I can also neither switch SHIFTLOCK on nor off... Am I doing something wrong??? I use version "USB Edition 5.09.00b2" Frank |
||||
| matherp Guru Joined: 11/12/2012 Location: United KingdomPosts: 9115 |
Wasn't implemented for USB keyboards Try this PicoMiteUSB.zip |
||||
| Frank N. Furter Guru Joined: 28/05/2012 Location: GermanyPosts: 828 |
Peter, thank you very much!!! You have removed UPDATE FIRMWARE and unfortunately the update mode cannot be forced via the TTL-USB converter when switching to 1200bps. On my small computer, the BOOT button is unfortunately not accessible from the outside (the display is in the way). Do you know of any other way to force the update mode? Is there perhaps a POKE or something similar? Frank |
||||
| matherp Guru Joined: 11/12/2012 Location: United KingdomPosts: 9115 |
Frank On the USB versions you have to use the BOOT button - no other way. Because the USB port is in host mode nothing else will work. |
||||
| Frank N. Furter Guru Joined: 28/05/2012 Location: GermanyPosts: 828 |
Ok! That's a pity! I have tried your version - the one with NUM now works. ...unfortunately the console output on the LCD no longer works after a restart. These are my OPTIONS: > option list PicoMite MMBasic USB Edition 5.09.00b4 OPTION SERIAL CONSOLE COM2,GP8,GP9 OPTION SYSTEM SPI GP18,GP19,GP16 OPTION SYSTEM I2C GP6,GP7 OPTION COLOURCODE ON OPTION KEYBOARD GR, 0, 0, 600, 150 OPTION CPUSPEED 252000 'KHz OPTION LCDPANEL CONSOLE OPTION DISPLAY 40, 100 OPTION LCDPANEL ILI9488, LANDSCAPE,GP15,GP14,GP13,GP2 OPTION TOUCH GP12,GP11,GP10 GUI CALIBRATE 0, 3969, 3900, -1228, -848 OPTION SDCARD GP22 OPTION AUDIO GP0,GP1', ON PWM CHANNEL 0 OPTION RTC AUTO ENABLE > Frank |
||||
| matherp Guru Joined: 11/12/2012 Location: United KingdomPosts: 9115 |
Frank, please could you try again. PicoMiteUSB.zip It wasn't working for me either and all I've done is re-compiled and now it is  |
||||
| Frank N. Furter Guru Joined: 28/05/2012 Location: GermanyPosts: 828 |
Ok, this version now also works for me. Thank you very much! P.S.: ...I'm just about to install a BOOT button...  Frank |
||||
 Print this page |
