Home
JAQForum Ver 24.01
Log In or Join  
Active Topics
Local Time 05:55 27 Nov 2024 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Microcontroller and PC projects : capacitor question re 5W AC-DC 12V 450mA Power Supply Buck Converter S

Author Message
sunwalker
Newbie

Joined: 17/11/2023
Location: Australia
Posts: 7
Posted: 10:14am 02 Dec 2023
Copy link to clipboard 
Print this post

I'm building some solar controller's, each has 2 of "5W AC-DC 12V 450mA Power Supply Buck Converter Step Down Modules" in it.
My experience is toddler level

I made an error on alibaba, ordering from the wrong seller, the modules & listed spec/parameters are identical between the 2 sellers.
The module image (below) on the plan has 2 x 470 uf 25v, which I meant to order, instead the modules image I ordered has the 2 x 470 uf but they are only 16v.

Due to my lack of experience, I don't know what the likely effect will be on the finished controllers performance, so any feedback as to how this might effect my project is welcome.

As it takes ~6 weeks to arrive,& they are cheap, If its likely to cause problems I can place another order of 15pk. (just a learning experience)  




Edited 2023-12-02 20:19 by sunwalker
 
phil99

Guru

Joined: 11/02/2018
Location: Australia
Posts: 2135
Posted: 11:18am 02 Dec 2023
Copy link to clipboard 
Print this post

As the output is 12V a 16V one on that side will be fine.
What is the input voltage? If it isn't much above 16V that may be ok too.
If they get warm or the top bulges unsolder them and fit higher rated ones.

In any case what turns up may have 25V capacitors despite the photo on the site.
 
Revlac

Guru

Joined: 31/12/2016
Location: Australia
Posts: 1024
Posted: 11:31am 02 Dec 2023
Copy link to clipboard 
Print this post

I just checked the one I have, its input cap is 400v 47uf, the output cap is also 16v 470uf.

You would have to lift up the capacitor to see the rating, or it just looks the same as each other
Edited 2023-12-02 21:32 by Revlac
Cheers Aaron
Off The Grid
 
sunwalker
Newbie

Joined: 17/11/2023
Location: Australia
Posts: 7
Posted: 04:44am 03 Dec 2023
Copy link to clipboard 
Print this post

  Revlac said  I just checked the one I have, its input cap is 400v 47uf, the output cap is also 16v 470uf.

That makes sense,(obvious) I never stopped to think each side would have a different rating, the large input voltage handles the high solar pv input, which for me will be ~ 100v. Thanks for both reply's, I managed to cancel the order & re ordered the higher v.
As soon as I figure out how to virtually test the controller, I'll have a better understanding.
 
Print this page


To reply to this topic, you need to log in.

© JAQ Software 2024