Home
JAQForum Ver 24.01
Log In or Join  
Active Topics
Local Time 07:50 24 Nov 2024 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Other Stuff : A simple anometer

Author Message
Air Bender
Senior Member

Joined: 25/01/2011
Location: Australia
Posts: 206
Posted: 06:44am 28 May 2011
Copy link to clipboard 
Print this post


This is a very simple anometer built by my son with a little bit of help from dad. And Surprisingly it is reading very acuratly.

It is built using a bike speedo and the hub of an old front bike wheel. The cups on the rotor are made from plastic balls that split in half and are filled up with decorations and hung on Xmas trees bought from the craft shop for $2 each.

Calabration was done by entering different wheel sizes into the speedo and also by ajusting the diameter of the rotor.

It was calabrated out of the car window and reads acuratly up to 50 km/h at higher speeds than that it was getting a bit hard to hold onto.
All the best

Dean.
 
Gizmo

Admin Group

Joined: 05/06/2004
Location: Australia
Posts: 5078
Posted: 07:33am 28 May 2011
Copy link to clipboard 
Print this post

Nice post Dean. Good idea using the bike hub, and the cups are a good size too. One of the best anometers I built used aluminium post end caps as cups. It was a little heavier than plastic cups, but performed well.

Good to see an old Commodore in such good condition too, they are getting rare these days.

One trick I picked up regarding vehicle testing. If its not a perfectly calm day, test drive in both directions, and calibrate to the difference in readings, the mid point.

Glenn
The best time to plant a tree was twenty years ago, the second best time is right now.
JAQ
 
Air Bender
Senior Member

Joined: 25/01/2011
Location: Australia
Posts: 206
Posted: 09:19am 28 May 2011
Copy link to clipboard 
Print this post

Hi Glenn
We tested it in both directions on a very calm day with it reading the same in both directions.
The commodore is mine but unfortunatly the wife loves it and i get to drive her ford most of the time. Its a V8 253 SLE with factory fitted cruise controle and 4 wheel disk brakes pretty cool for a car 25 years old. it still has all the original running gear and the motor still dosnt need to be topped up between changes.
It is a bit thirsty but it is the car of choice when we go on a long trip.

All the best

Dean.
 
Gizmo

Admin Group

Joined: 05/06/2004
Location: Australia
Posts: 5078
Posted: 11:46am 28 May 2011
Copy link to clipboard 
Print this post

Hi Dean

Yeah I though it looked like the V8, I noticed the heavy duty tow bar and twin exhaust. I had a 253 once in a HQ, nice motor.

Dont forget to write down the wheel size you used on the bike speedo. When the battery goes flat you'll have to re-enter the calibration.

Glenn
The best time to plant a tree was twenty years ago, the second best time is right now.
JAQ
 
Print this page


To reply to this topic, you need to log in.

© JAQ Software 2024