TheBackShed.com

Home	JAQForum Ver 24.01
Log In or Join
Active Topics
Local Time 09:48 25 Nov 2024	Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Other Stuff : Hot Water Thermal Losses

Page 2 of 2

Author

Message

Downwind

Guru

Joined: 09/09/2009
Location: Australia
Posts: 2333

Posted: 05:24am 03 May 2014

Copy link to clipboard

Print this post

Quote Perhaps you could cover with the Styrofoam, fill with PU expanding foam and apply a layer of F/glass to keep it all together? The PU and poly styrene foams both shape well using very coarse sandpaper.

All good, but this could read as glassing over styofoam is recommended, and simply it wont work, as the vapors alone in polyester resin will melt the foam regardless if its in direct contact or not.
Although PU expanding foam can be glassed over with no problems as Mobi has suggested.

Pete.

Sometimes it just works

MOBI
Guru

Joined: 02/12/2012
Location: Australia
Posts: 819

Posted: 01:29pm 03 May 2014

Copy link to clipboard

Print this post

Quote All good, but this could read as glassing over styofoam is recommended, and simply it wont work, as the vapors alone in polyester resin will melt the foam regardless if its in direct contact or not.
Although PU expanding foam can be glassed over with no problems as Mobi has suggested.

Sorry, I should have specified epoxy not polyester. Even so, you can use polyester resin on polystyrene if you paint it first with a good coat or two of neutral sealant such as acrylic paint.

David M.

Page 2 of 2

Print this page

To reply to this topic, you need to log in.