TheBackShed.com

Home	JAQForum Ver 24.01
Log In or Join
Active Topics
Local Time 07:32 25 Nov 2024	Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Other Stuff : Ni-Zn batteries instead of Ni-Mh

Author

Message

Georgen
Guru

Joined: 13/09/2011
Location: Australia
Posts: 462

Posted: 12:16am 19 Jan 2014

Copy link to clipboard

Print this post

Ni-Mh batteries are 1.2 V and Ni-Zn 1.6V

Many of the devices that operate on 1.5V batteries seem to just make it on 1.2V

Is it safe to assume that they will be also OK on higher voltage?

What worries me is that 4 batteries that are effectively re-charged to 1.8V give 7.2V instead of required 6.0V

Quite a difference

George

MacGyver

Guru

Joined: 12/05/2009
Location: United States
Posts: 1329

Posted: 08:40pm 19 Jan 2014

Copy link to clipboard

Print this post

Georgen

I build and play with R/C electric aircraft. When I build a plane, it is quite necessary that I "match" the components. When I choose a battery and a speed control, I have to make sure to get a speed control, which is rated IN EXCESS of the battery's rated peak voltage and current or run the risk of a very expensive airplane flying off to parts unknown!

Your question is along these same lines. I think what you'll have to do is take a look at whatever application you intend putting your battery into. If the battery's potential is greater than the motor or other application can handle, that's where you'll get into trouble.

In my line of toys, a motor, battery, speed control, receiver and servos can cost upwards of $200 sometimes, so a little care down on the ground before you toss your baby into the air is essential.

Hope this helps you on your quest.

. . . . . Mac

Nothing difficult is ever easy!
Perhaps better stated in the words of Morgan Freeman,
"Where there is no struggle, there is no progress!"
Copeville, Texas

Print this page

To reply to this topic, you need to log in.