Home
JAQForum Ver 24.01
Log In or Join  
Active Topics
Local Time 23:57 24 Nov 2024 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Other Stuff : Attaching copper wire to tube

Author Message
imsmooth

Senior Member

Joined: 07/02/2008
Location: United States
Posts: 214
Posted: 03:12pm 23 Apr 2013
Copy link to clipboard 
Print this post

I want to solder copper wire to some stainless steel tubing to increase the surface area I'm working on a regenerative cooler any tips on the best way to ataxic copper wire to the stainless steel tubing would just plain soldering work

I'm trying to create feigns to increase the surface area
 
MOBI
Guru

Joined: 02/12/2012
Location: Australia
Posts: 819
Posted: 12:15am 24 Apr 2013
Copy link to clipboard 
Print this post

  Quote  I want to solder copper wire to some stainless steel tubing to


Is the copper wire insulated (varnish coated) or plain copper?

Both copper and stainless steel will take lead/tin solder quite happily provided you use adequate flux. Zinc chloride (killed spirit) will work well especially with a solder or tin paste.
David M.
 
Ron B
Newbie

Joined: 26/04/2013
Location: Australia
Posts: 5
Posted: 11:15pm 26 Apr 2013
Copy link to clipboard 
Print this post

Would it be easier to make or obtain some stainless washers and fit them to the tube as fins? what is the tube diameter and length?

 
Print this page


To reply to this topic, you need to log in.

© JAQ Software 2024