Home
JAQForum Ver 24.01
Log In or Join  
Active Topics
Local Time 21:37 24 Nov 2024 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Other Stuff : Gotta love christmas

Author Message
yahoo2

Guru

Joined: 05/04/2011
Location: Australia
Posts: 1166
Posted: 05:19pm 05 Jan 2013
Copy link to clipboard 
Print this post

I have been putting up with a worn out MIG torch on my little welder for a couple of years now. The outer casing that carries the shielding gas is officially beyond repair, no amount of vulcanising patches will resurrect it.

As usual, I can not buy the cable on its own.

So I ordered a complete Bernard assembly. Knock off copy of course, because the OEM replacement assembly for my model is no longer available.

My welding supplies shop got sent some Genuine 300 amp Bernard guns instead of the copies from their supplier. And only about $70 extra.

I am beginning to believe in Santa again.


I'm confused, no wait... maybe I'm not...
 
Downwind

Guru

Joined: 09/09/2009
Location: Australia
Posts: 2333
Posted: 05:33pm 05 Jan 2013
Copy link to clipboard 
Print this post

Well that should make the sparks fly.

Im still cursing my last mistake of replacing the 15kg roll of wire where i picked it up from one side of the spool and the spool split in the centre, expanding the roll now it feeds wire when it feels like it, and normally binds up right at the very important part of the project weld.

Im still hoping to get enough use off the roll of wire before i need to rewind it onto a empty spool not looking forward to that

Pete.
Sometimes it just works
 
Print this page


To reply to this topic, you need to log in.

© JAQ Software 2024