Home
JAQForum Ver 24.01
Log In or Join  
Active Topics
Local Time 22:45 23 Nov 2024 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Other Stuff : Solar cooker?

Author Message
KarlJ

Guru

Joined: 19/05/2008
Location: Australia
Posts: 1178
Posted: 09:52am 18 Jul 2010
Copy link to clipboard 
Print this post

has anyone tried to build one?
I have some ripper sandwich panels that are foil/foam 1" then foil,
look like they will make a good oven hence plans / angles would be great!
Luck favours the well prepared
 
MacGyver

Guru

Joined: 12/05/2009
Location: United States
Posts: 1329
Posted: 03:29pm 19 Jul 2010
Copy link to clipboard 
Print this post

KarlJ

I've built a few and insulation is "key". Each of mine got hot enough to bake bread. Now, mind you, cooking takes a bit longer but aside from a little plastic smell the first couple of runs, they work like a charm.


This Link shows one that sells commercially for around a hundred bucks. Both my designs were very similar except I used a single sheet of glass for the top cover. I think the one in the video is double-layered if I remember correctly. That would be a plus; like I said, "Insulation is key".

One thing to watch out for is if you use cast iron cooking pots, the iron retains so much of the heat, it can harm whatever surface it sits on. I had mine sitting right on the foam insulation block and the heat 'melted' a dent in the surface after a few runs. I later substituted a thin slab of slate (rock) and it cured the problem.

I gave one away and kept one for emergencies. The hardest part will be remembering where I stashed it!


. . . . . Mac


Edited by MacGyver 2010-07-21
Nothing difficult is ever easy!
Perhaps better stated in the words of Morgan Freeman,
"Where there is no struggle, there is no progress!"
Copeville, Texas
 
brucedownunder2
Guru

Joined: 14/09/2005
Location: Australia
Posts: 1548
Posted: 09:54pm 19 Jul 2010
Copy link to clipboard 
Print this post

Yes, Brett from newcastle builds and sells them and I think will sell the plans .

His demo model is on this forum --but way back ,, you'll have to do some searching ..

Bruce
Bushboy
 
Print this page


To reply to this topic, you need to log in.

© JAQ Software 2024