Home
JAQForum Ver 24.01
Log In or Join  
Active Topics
Local Time 20:27 22 Nov 2024 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Other Stuff : CNC Kit Recommendations

Author Message
darcyrandall200

Newbie

Joined: 17/01/2009
Location: Australia
Posts: 34
Posted: 12:45am 17 Jan 2009
Copy link to clipboard 
Print this post

Hello all,

Since coming across this site I have already built one F&P wind turbine and have started a second. Now I have another itch. I am considering building a CNC machine.

The kit on offer at www.mechmate.com is the dream yet I am worried I do not have the technical skills yet to create such a thing.
The kit on offer at http://buildyourcnc.com I believe will be an easy build yet I am not sure wether it will be capable of performing tasks such as carving windmill blades or carving a lump of aluminum into a box.

Has anyone else got any thoughts or other recommendations.
Thankyou.

Regards Darcy Randall, Perth Western Australia
 
Gizmo

Admin Group

Joined: 05/06/2004
Location: Australia
Posts: 5078
Posted: 01:56am 17 Jan 2009
Copy link to clipboard 
Print this post

Have you seen my CNC page at http://www.thebackshed.com/cnc.
Check out the link to Ocean Controls, they sell steppers and microsteping controllers for a good price. There also now cary a range of servo motors and servo amps, about 3 times the price as steppers but worth it if you want to get serious.
For software I use the Linuz EMC2 software on Unbuntu, its fast but not very user friendly. I also recommend KCam.

Glenn
The best time to plant a tree was twenty years ago, the second best time is right now.
JAQ
 
darcyrandall200

Newbie

Joined: 17/01/2009
Location: Australia
Posts: 34
Posted: 03:42am 18 Jan 2009
Copy link to clipboard 
Print this post

Cheers Glen,

I have checked out your CNC machine. Did you design the device yourself or does a kit exist for your machine?

Thankyou
Thankyou.

Regards Darcy Randall, Perth Western Australia
 
stevet47

Newbie

Joined: 12/09/2008
Location: United States
Posts: 7
Posted: 05:07pm 30 Jan 2009
Copy link to clipboard 
Print this post

If you want to build your own CNC, you NEED to check out www.cnczone.com

Their is an astounding amount of info on there, and an entire section devoted to DIY CNC machines. They are several downloadable measured drawings, 3D renderings etc.
 
Print this page


To reply to this topic, you need to log in.

© JAQ Software 2024