TheBackShed.com

Home	JAQForum Ver 24.01
Log In or Join
Active Topics
Local Time 14:24 22 Nov 2024	Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Other Stuff : MSW inverter with welder

Author

Message

greendreamin
Newbie

Joined: 02/02/2008
Location: Australia
Posts: 20

Posted: 12:07pm 26 Jun 2008

Copy link to clipboard

Print this post

wondering if anybody has had experience using a small cheapo bunnings arc welder with a Mod sine wave inverter. just planning on doing little jobs no more than 5 mins, inverter is a 2000w cont think surge is 4500w, the welder is 160a output max.
thanks stu

AMUN-RA

Senior Member

Joined: 10/03/2007
Location: Australia
Posts: 144

Posted: 03:45pm 26 Jun 2008

Copy link to clipboard

Print this post

have done it but welds are not the best I've done try and see let us know Mick.

Every day the sun shines
& gravity sucks= free energy.

martinjsto

Senior Member

Joined: 09/10/2007
Location: Australia
Posts: 149

Posted: 10:12am 27 Jun 2008

Copy link to clipboard

Print this post

yep done some seriouse welding for a 3 tonne excavator on my farm last spring, good sunny day and 660 amp hrs at 24v connected to a solar 4000w surge 1650 continuouse inverter,
worked realy well but sugest lots of prep and pre-heating job prior to welding, i used carbon rods at 120 amps it ran for more than an hour in total, i took a few breaks to let things cool down in between but all went well
good luck
martin

free power for all
McAlinden WA

Print this page

To reply to this topic, you need to log in.