Home
JAQForum Ver 24.01
Log In or Join  
Active Topics
Local Time 11:43 25 Nov 2024 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Other Stuff : Dunlight UH5 generator

Author Message
windlight
Guru

Joined: 03/03/2007
Location: Australia
Posts: 331
Posted: 06:05am 03 Sep 2018
Copy link to clipboard 
Print this post

My old faithful has failed, now it has had numerous capacitors in it's life but this time the trouble goes deeper. Brush less generator Voltage comes up but fails on load, I assume the two blue discs on the rotor are diodes. I cant quite make out numbers in situ but of what I think I can read is s20k below that 420???. Any advice before i take to it with a soldering iron.





"I like this place and willingly could waste my time in it" - (Act II, Scene IV).
 
Revlac

Guru

Joined: 31/12/2016
Location: Australia
Posts: 1024
Posted: 07:08am 03 Sep 2018
Copy link to clipboard 
Print this post

I'm not familiar with that particular model, but the one here I think it has 1 diode, it also failed, replaced that diode and it has being running ever since, well occasionally it dose not excite, just drop the revs to idle then let it go again.
I think the diode were high speed?
Cheers Aaron
Off The Grid
 
Print this page


To reply to this topic, you need to log in.

© JAQ Software 2024