Home
JAQForum Ver 24.01
Log In or Join  
Active Topics
Local Time 16:15 27 Nov 2024 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Solar : Solar Monitor for Sony PSP :)

Author Message
Art_

Newbie

Joined: 22/10/2007
Location: Australia
Posts: 30
Posted: 01:53am 02 Jan 2008
Copy link to clipboard 
Print this post

Hi Guys,
Thought you might like this...
As I use a dedicated 10 Watt solar charger for my PSP,
it made sense to write some functionality to monitor it's own charger.

http://au.youtube.com/watch?v=yioC2p-rVrM

While camping, I am running this program for other reasons.
Since the PSP unit is constantly running, incorporating these routines
means I get a solar logger for free.

The PSP doesn't know input voltage at it's power connector,
just that it's over the threshold required to power the unit,
so the graph is like a yes or no state.
Monitoring the battery voltage of the PSP is possible though.

I'm a programmer, so if you rate my video, round it off to the nearest extreme :)
Cheers, Art.
If not actually, then potentially.
 
Art_

Newbie

Joined: 22/10/2007
Location: Australia
Posts: 30
Posted: 02:05am 02 Jan 2008
Copy link to clipboard 
Print this post

link:
http://au.youtube.com/watch?v=yioC2p-rVrM
Edited by Art_ 2008-01-03
If not actually, then potentially.
 
Robb
Senior Member

Joined: 01/08/2007
Location: Australia
Posts: 221
Posted: 03:35am 02 Jan 2008
Copy link to clipboard 
Print this post

  Art_ said  ...... The PSP doesn't know input voltage at it's power connector,
just that it's over the threshold required to power the unit,......


Are you sure you won't fry the unit . Most panels go well over there rated voltage at full sun and light loads. If it uses a switching reg and suitably rated capacitors and other input componentry you may be lucky but surface mount caps dont like too much extra voltage.
 
Art_

Newbie

Joined: 22/10/2007
Location: Australia
Posts: 30
Posted: 04:05am 02 Jan 2008
Copy link to clipboard 
Print this post

The PSP is powered via a 5 Volt regulator.
I used a car lighter adapter that was rated up to 30 Volts,
so the unit is safer than it would be if it were plugged
into the mains ;)

My post does suggest otherwise...
good pick up.
The PSP would almost always see 5 Volts anyway.
Edited by Art_ 2008-01-03
If not actually, then potentially.
 
Print this page


To reply to this topic, you need to log in.

© JAQ Software 2024